The DeCA and the e-CMR do not compete with each other. The DeCA (Spain's electronic administrative control document) is the mandatory control document for road freight with origin and destination in Spain, cabotage included, while the e-CMR is the electronic version of the international consignment note under the CMR Convention. If a truck loads in Zaragoza and unloads in Toulouse, it carries a CMR or e-CMR; if it loads in Zaragoza and unloads in Valencia, it carries a DeCA. Below are the differences between the DeCA and the e-CMR, the cases that cause most confusion and what the June 2026 Resolution says about other formats and about eFTI.
What each document is
The DeCA, Spain's domestic control document
The DeCA (documento electrónico de control administrativo) is the digital version of the control document regulated by Order FOM/2861/2012. Under Law 9/2025 of 3 December on Sustainable Mobility, it must be digital from 5 October 2026 for road haulage for hire or reward. It is an administrative document: it tells the Land Transport Inspectorate and roadside officers who contracted the job, who is carrying it, what is on board and where it is going from and to.
Its format is set by the Resolution of 5 June 2026 of the Directorate-General for Road and Rail Transport: a native PDF of up to 5 MB, a QR code inside the document and an https URL that downloads the PDF directly, with no username or password.
The CMR and e-CMR, the international consignment note
The CMR consignment note is the one under the Convention on the Contract for the International Carriage of Goods by Road, which governs road haulage between countries. The e-CMR is its electronic version and relies on an additional protocol to that convention. Unlike the DeCA, the CMR is first and foremost the document of the contract of carriage between the parties.
No DeCA is needed for international transport because article 222.1 of the regulation implementing Spain's Land Transport Act (ROTT) states that international journeys use the control documents set out in the conventions Spain has signed. The June Resolution itself repeats the point: international transport that passes partly through Spanish territory falls outside the DeCA.
Differences between the DeCA and the e-CMR
| Aspect | DeCA | CMR or e-CMR |
|---|---|---|
| When it is used | Domestic transport (origin and destination in Spain) and cabotage in Spain | International road transport |
| Legal basis | Order FOM/2861/2012, Law 9/2025 and the Resolution of 5 June 2026 | CMR Convention and its additional protocol on the electronic consignment note |
| Nature | Administrative control document | Document of the contract of carriage, which also acts as the control document for international journeys |
| Technical format | Native PDF of up to 5 MB, QR code inside the PDF and https URL with direct download | Whatever the protocol and the e-CMR platform in use provide for |
| Signature | Not mandatory; if also used for contractual purposes and signed, at least an advanced electronic signature | Part of its role as a contract document |
| Parties identified | Contracting shipper (cargador contractual) and actual carrier (transportista efectivo) | Sender, carrier and consignee, among other details |
The difference you notice most day to day is the parties. The DeCA requires the contracting shipper to be identified, and that may be a freight agency rather than the factory doing the loading, whereas the CMR talks about the sender. That is why one cannot always be copied into the other without thinking.
When to use a DeCA and when to use an e-CMR
The practical rule is to look at where each consignment starts and ends. These are the cases that come up most often in a planning office.
Domestic job, Castellón to Bilbao
Cerámicas del Ebro sends 20 pallets of tiles from its factory in Onda to a warehouse in Bilbao with Transportes Moncayo. Origin and destination are in Spain, so it needs a DeCA. If the following week the same customer sends an identical load to Bordeaux, that trip is international and goes with a CMR or e-CMR, even though most of the route runs on Spanish roads.
Cabotage in Spain by a foreign truck
A French haulier unloads in Getafe a consignment it brought from Lyon with its CMR. Before heading home, it loads 22 pallets in Getafe for Seville. That second job is cabotage, because it has origin and destination in Spain and is carried out by a haulier from another country. It needs a DeCA, and the actual carrier is the French company.
The most practical arrangement is usually for the Spanish contracting shipper, for example the freight agency that booked the job, to issue it and send the link or QR code to the driver by WhatsApp or email. The rules do not regulate the language of the PDF, but if the driver does not read Spanish it helps if the document also carries labels in English. Who is liable for each field in these situations is explained in contracting shipper and actual carrier.
Transit through Spain without loading or unloading
A Portuguese truck going from Porto to Lyon crosses half the Iberian Peninsula, but its consignment is international from start to finish. It carries a CMR or e-CMR and needs no DeCA for the Spanish stretch. It would be different if, on the way back, it loaded in Zaragoza for Madrid: that job would be cabotage and would need a DeCA.
A truck with a mixed load
Transportes Moncayo leaves Onda with 12 pallets for Lyon and 8 for a customer in Barcelona. Each consignment is documented according to its own origin and destination: the Lyon one with a CMR or e-CMR and the Barcelona one with a DeCA. Order FOM/2861/2012 organises the control document by consignment, so both documents can travel in the same truck, and the prudent approach is for the driver to have both to hand in case of a check before Barcelona.
A container arriving by sea at the port of Valencia
A container arrives by sea from Shanghai at Valencia and Moncayo takes it by road to a warehouse in Riba-roja de Túria. The road leg starts and ends in Spain, so in principle it is domestic transport and needs a DeCA. Multimodal operations under a single contract from start to finish may have their own nuances, and if that is how you work it is worth confirming with your trade association or with the Inspectorate.
A similar case is a semi-trailer shipped from Valencia to Palma. The Resolution points out that domestic transport may cross non-Spanish waters because of its route in a multimodal operation and still count as domestic.
Other formats that can serve as a DeCA
The Resolution of 5 June 2026 (BOE of 12 June 2026) deals with this in its eighth section. It allows the DeCA to use the format of other transport documents: consignment notes, the ADR dangerous goods transport document, the waste identification document (DI), the SANDACH animal by-products document or any other format used to document a transport service. The condition is that it includes all the data in article 6 of Order FOM/2861/2012 and identifies the contracting shipper and the actual carrier expressly and separately.
This matters if you already use an e-CMR platform for international work and want to use it for domestic jobs too. The prudent reading is that the consignment note format is acceptable, but the document must also meet what the Resolution requires of any DeCA: a native PDF, a QR code inside the document and a URL with direct download and no credentials. If your e-CMR platform does not do that, you will need another tool for domestic transport. Ask your provider in writing before taking anything for granted.
Where eFTI fits in
eFTI is the acronym for Regulation (EU) 2020/1056 on electronic freight transport information. The June Resolution takes it into account in its ninth section: if the article 6 data are managed and presented using the scheme of that regulation and its implementing regulations, the DeCA does not have to be presented in the form described in the Resolution.
It is best not to jump ahead. For that route to work for you, your provider has to work with the eFTI scheme and the information has to be presentable through that channel. Until you have that confirmed, the safe route for a domestic job is the DeCA as a PDF with its QR code.
Common mistakes when mixing the two documents
- Using a paper consignment note for a domestic job. From 5 October 2026 the control document for domestic transport has to be digital, so a paper form no longer does that job within Spain.
- Assuming the CMR for the international leg covers the cabotage job that follows. They are separate consignments, and the cabotage one needs its own DeCA.
- Using the e-CMR domestically without identifying the contracting shipper. If the platform only distinguishes between sender and carrier, one of the eighth section's conditions is missing.
- Issuing a DeCA for an international job. It does not replace the CMR or e-CMR required by the convention, however well the document is drawn up.
If your fleet runs both domestic and international work
It is common for the same trucks to do both in the same week, and that is where things get muddled. Three habits help:
- Decide the document per consignment, not per truck or per customer.
- State clearly on the loading order which document each consignment carries, so the driver does not have to guess.
- Have both systems in place: the CMR or e-CMR for international work and the DeCA for domestic transport and cabotage.
For the full legal background on the domestic control document, see the page on Spain's DeCA law, and if your concern is the timetable, here is what changes on 5 October 2026.
LeyDeca focuses on the domestic side: it issues the DeCA for your domestic and cabotage jobs, with the link ready to send to the driver even if they work for a foreign company, while the e-CMR for international work stays on your usual platform. You can see how it fits each type of company in DeCA for carriers and shippers.



